How To Make RC Plane from former cork

advances in technology today has brought much change in equipment entertainment or children's toys. toys that were once synonymous with the kids, but when now it is not limited in terms of age / age. both children and adults all would like to play, it's just a toy that is played today is slightly different with toys masalalu that do not use the technology and how to play just maenggunakan imagination but now has turned into a toy sophisticated technology which uses system waves. I want to share a bit of knowledge about general wave that is around us, the wave are: Wave Ultrasonic and infrasound in which the range of frequencies that can still be heard by the human ear is from 20 Hz to 20 000Hz frequencies below 20Hz are called infrasound, while those above 20 000Hz called Ultrasonic.

do you know the remote control plane is one of the main application of Bernoulli's Law.

Some equipment that applies Bernoulli law perinsip as follows;

1. atomizer repellent and perfume

2. kaburator

3. lift aircraft

4. venturi meters

5. Pitot tube



    The aircraft can fly up in the air because the air velocity through the air wing of the upper side (V2) is greater than on the bottom side of the wing (V1). therefore, the pressure of the top (P2) is smaller than the pressure at the bottom (P1) This pressure difference (P1 - P2) raises lift the magnitude defined by the following equation (picture)



F1-F2 = (P1 - P2) A

So that the aircraft can be lifted up / aerial lift aircraft must be greater than the weight of the aircraft.

If the aircraft will float with a fixed height, aircraft lift force must equal the weight of the aircraft style. F1-F2 = m.g

of the above theory we can take lessons and practice by making the plane.

at this stage let's start making.

the first step we have to do to make a remote water lontrol must prepare tools and materials.

equipment and materials used are

BASIC SETUP (60+ mph)

1. Motor: A2212 1000KV outrunner Brushless motors

2. ESC: 30A Brushless ESC

3. Prop: APC 8x4 (or better recomended)

4. Battery: 2200 mAh, 11,1V (25C or better recomended)

5. Servos: 2 each Micro Servo

6. Radio & Receiver: Any 6-channel or better (2.4 GHz preferred)

7. fly control: an open pilot

 WORKING TOOL:

1. Cutter

2. Ruler

3. pen / pencil

4. duct tape

5. Wire

6. Glue

7. carton

Materials to be used:

1. The former cork, or foamboard, or depron or fan fold foam can be used with improvised carbon spars where needed

2. flywood or Baswood sheets.

Then you can follow the shape and size below

(Pictures)

see the video below to assemble the fuselage! (VIDEO)

How To Make RC Plane from former cork
9out of 10 based on 10 ratings. 9 user reviews.